Yandex MC
Elsa online. ElsaWin. ElsaWeb. VWDiesel fuel filter: Renew (Diesel engine)

elsawin online

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru

Attention! Please use superetka.com/elsa

Touareg

Please use
superetka.com/elsa

PLEASE USE https://SUPERETKA.COM/elsa
elsa on kolhosniki not support now!

Diesel fuel filter: Renew (Diesel engine)
  Note
After changing the diesel fuel filter, the fuel system must be bled.
Removing:
Remove engine cover panel. → Chapter
  Note
t  Ensure that no diesel fuel contacts coolant hoses.
t  If necessary, clean hoses immediately.
t  Observe disposal regulations!
Carry out the following procedure:
   
–  Remove bolts -arrows-.
  N01-11054
–  Lift off diesel fuel filter upper part -1- with fuel lines connected.
–  Pull out diesel fuel filter element -4- from diesel fuel filter lower part.
  Note
Observe disposal regulations!
  Caution
If necessary, remove dirt and water residues from diesel fuel filter lower part.
  N01-11055
Installing:
  Caution
The seals -2- and -3- and diesel fuel filter element -4- must be renewed.
Always moisten new seal -2- slightly with diesel fuel to avoid malfunctions!
  N01-11056
–  Insert new diesel fuel filter element in diesel fuel filter lower part and slightly turn to limit stop.
–  Fit diesel fuel filter upper part -1- with seal on diesel fuel filter lower part and start bolts approx. one turn.
  Caution
Ensure correct installation position of diesel fuel filter upper part to lower part.
  N01-11055
–  Tighten bolts -arrows- alternately and diagonally.
–  Tighten bolts to 5 Nm torque.
Bleeding fuel system:
l  Vehicle must have fuel.
  N01-11054
ODIS Service
–  Connect diagnostic tester → Chapter.
–  Switch on ignition.
–  Carry out identification of vehicle.
–  Enter task data or select “Without task”.
–  Select “Control unit list”.
–  Select “Engine electronics”.
–  Select “Guided functions”.
–  Select “Activate fuel pump”.
–  Follow instructions on vehicle diagnostic tester in “Guided functions” mode.

–  After the fuel system has been bled, start engine.
–  Allow engine to run for several minutes at mid revs, then switch engine off again.
–  Read event memory and erase if necessary.
–  Carry out a leakage test of the fuel system.
  Note
If there is still air in the fuel system, the engine can change to emergency running mode during road test. In this case, switch engine off and erase fault memory. Then continue with a road test.
   

Didn't find what you were looking for? Try to find in:
- Mitchell onDemand online


- ETKA ONLINE - login-pass from kolhosniki.ru

- NEW ELSA ONLINE - login-pass from kolhosniki.ru
Loading...

This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20