2004-08 ACCESSORIES AND EQUIPMENT
Power Moonroof - TSX
Component Location Index
Fig. 1: Identifying Moonroof Component Location
Circuit Diagram
Fig. 2: Moonroof - Circuit Diagram
Switch Test
NOTE: |
The moonroof can still be operated for about 10 minutes after the ignition switch is turned from the "II" to the "I" or "0" positions, as long as none of the doors are opened. |
- Carefully pry out the switch panel (A), then disconnect the 6P connector (B) from the switch.
Fig. 3: Identifying Switch Connector Terminal
- Carefully push out the moonroof switch (C) from behind the switch panel.
- Check for continuity between the terminals in each switch position according to the table.
Fig. 4: Terminal Continuity Chart
- If the continuity is not as specified, replace the bulb (D) or the switch.
Moonroof Motor Test
- Remove the headliner (see
HEADLINER REMOVAL/INSTALLATION
).
- Disconnect the 2P connector (A) from the moonroof motor.
Fig. 5: Identifying Moonroof Motor 2P Connector Terminal
- Check the motor by connecting power and ground according to the table.
Fig. 6: Power And Ground Connection Terminal Chart
- If the motor does not run, replace it.
Limit Switch Test
- Remove the headliner (see
HEADLINER REMOVAL/INSTALLATION
).
- Disconnect the 4P connector (A) from the moonroof limit switch (B).
Fig. 7: Identifying Moonroof Limit Switch 4P Connector Terminal
- Check for continuity between the terminals in each switch position according to the table.
Fig. 8: Terminal Continuity Chart
- If the continuity is not specified, replace the moonroof motor assembly.