2004-08 ACCESSORIES AND EQUIPMENT
Ignition Switch - TSX
Test
SRS components are located in this area. Review the SRS component locations (see
COMPONENT LOCATION INDEX
) and precautions and procedures (see
PRECAUTIONS AND PROCEDURES
) in the SRS before performing repairs or servicing.
- Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped), then write down the audio presets.
- Disconnect the battery negative cable.
- Remove the left front door sill trim and left kick panel (see
TRIM REMOVAL/INSTALLATION - DOOR AREAS
).
- Disconnect the 6P connector from the driver's under-dash fuse/relay box.
Fig. 1: Identifying Driver's Under-Dash Fuse/Relay Box 6P Connector Terminal
- Check for continuity between the terminals in each switch position according to the table.
Fig. 2: Continuity Terminals Reference Chart
- If the continuity checks do not agree with the table, replace the steering lock.
- After reconnecting the battery, enter the anti-theft code for the audio system and the navigation system (if equipped), then enter the audio presets. Set the clock (on vehicles without navigation).
- Do the engine idle learn procedure (see
ECM/PCM IDLE LEARN PROCEDURE
) and the power window control unit reset procedure (see
RESETTING THE POWER WINDOW
).