Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



1.Install side gears and thrust washers in correct order.
2.Lubricate thrust face of side gear and plates and discs with suitable lubricant and assemble plates and discs to side gear splines.
3.Assemble retainer clips to ears of plates, ensuring that clips are completely assembled or seated onto ears of plates.
4.Assemble clutch pack and side gear into case, ensuring that clutch pack stays assembled to side gear splines and that retainer clips are completely seated into pockets of case.
5.Manually retain clutch pack in case, position case on bench, and assemble step plate into side gear, applying small amount of lubricant into centering hole of step plate.
6.Assemble remaining clutch pack and side gear, ensuring that clutch pack stays assembled to side gear splines and that retainer clips are completely seated into pockets of case.
7.Position gear rotating tool into top side gear, manually hold side gear and rotating tool in position, insert forcing screw down through top of case, and thread screw into rotating tool until screw contacts step plate.
8.Position case onto axle shaft by aligning splines of side gear with splines of shaft.
9.Position differential pinion gears opposite one another through openings in case, ensuring that holes of gears are aligned, manually retain gears in position, and tighten forcing screw so that side gears move away from differential pinion gears.
10.
Hold differential pinion gears in place and insert pawl of rotating tool between two side gear teeth, then pull on handle so that top side gear rotates and allows differential pinion gears to rotate and enter into case. It may be necessary to slightly tighten or loosen forcing screw to permit gear movement.
11.
Put on tool until handle hits case, then remove pawl from between gear teeth and position handle and pawl. Repeat this step until holes of differential pinion gears are perfectly aligned with holes of case.
12.
Lubricate both sides of pinion spherical washers with suitable lubricant.
13.
Apply torque to forcing screw to obtain installation clearance for spherical washers.
14.
Install spherical washers, ensuring that holes of washers and gears are perfectly aligned with holes of case, then remove forcing screw, rotating tool, and step plate.
15.
Install pinion shaft in differential case, then the cross shaft locking pin.



This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20