Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



REMOVAL
1.Remove push rod and retainer bushing from cross-shaft lever pin.
2.Disconnect interlock switch connector plug.
3.Remove two nuts and support bracket retaining clutch reservoir and master cylinder assembly to firewall.
4.Disconnect hydraulic tube from clutch master cylinder.
5.Remove clutch reservoir and master cylinder assembly from firewall.
6.Remove clutch master cylinder from vehicle.

INSTALLATION
1.Reverse procedure to install, noting the following:
a.Ensure routing of tubes follows same routing as removal, keeping all tubes away from hot exhaust pipes. Install all tubing retaining clips.
b.Ensure clutch fluid is full, then depress clutch petal at least ten times to verify smooth operation and proper release. Do not overfill reservoir, as upper part must accept fluid that is displaced from slave cylinder as clutch wears.
c.Bleed system.


This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20