Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



1.Clean reservoir cap and slave cylinder in area of tube connection.
2.Remove slave cylinder from transmission bellhousing, then use a 3/32 inch punch to drive out pin that holds tube. Remove tube from slave cylinder and place end into a container of waste fluid.
3.Hold slave cylinder so connector port is at an angle of approximately 30° then fill with approved DOT 3 brake fluid. Rock or push gently on push rod to expel all air. Ensure no moisture or dirt enters slave cylinder.
4.Ensure all air is expelled, then install slave cylinder.
5.Gravity fill master cylinder and tube. Fluid should flow from open end of tube into waste container, but clutch master cylinder reservoir must be kept full. When fluid is flowing at a steady rate and fluid level is at step in reservoir, install diaphragm and cap, then the end of tube into slave cylinder.
6.Replace pin that holds tube to slave cylinder.
7.Remove slave cylinder from transmission. Then, while holding cylinder so that tube port is at highest point, push pushrod slowly into cylinder and slowly release.
8.Install slave cylinder on transmission, then cycle clutch pedal rapidly 10 times through a travel of approximately 1 inch and wait 2 minutes. Pedal should be hard within 1/4 to 1/2 inch of travel.
9.Verify correct clutch operation by starting vehicle and attempting to shift into Reverse from Neutral position. If gears clash, clutch hydraulic system may not be fully bled, or other components may be at fault.




This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20