Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



{tag}844657908@


Some lever assemblies, Fig. 6, incorporate an oil impregnated plastic grommet in the end of the lever arm.

1.Place the lower jaw of the tool between the manual lever and control rod. Position the stop pin against the end of the control rod and force the rod out of the grommet. Remove grommet from manual lever by cutting off the large shoulder with knife. The grommet must be removed from the manual lever and a new one installed each time the rod is disconnected.
2.Prior to installing a new grommet, adjust the stop pin to 1/2 inch and coat the outside of the grommet with lubricant. Then place the grommet on the stop pin and force it into the manual lever hole. Turn the grommet several times to ensure it is properly seated.
3.Adjust stop pin to the height shown in Fig. 6. The pin height is determined by the length of the rod end which is to be installed into the grommet. If the pin height is not adjusted, the control rod may be pushed too far through the grommet, causing damage to the grommet retaining lip.
4.With the pin height properly adjusted, position the control rod on the tool and force the rod into the grommet until the groove in the rod seats on the inner retaining lip of the grommet. Ensure the rod protrudes through the grommet approximately 1/4 inch after installation.Fig. 6 Replacement Of Shift Linkage GrommetFig. 6 Replacement Of Shift Linkage Grommet



Some lever assemblies, Fig. 6, incorporate an oil impregnated plastic grommet in the end of the lever arm.

1.Place the lower jaw of the tool between the manual lever and control rod. Position the stop pin against the end of the control rod and force the rod out of the grommet. Remove grommet from manual lever by cutting off the large shoulder with knife. The grommet must be removed from the manual lever and a new one installed each time the rod is disconnected.
2.Prior to installing a new grommet, adjust the stop pin to 1/2 inch and coat the outside of the grommet with lubricant. Then place the grommet on the stop pin and force it into the manual lever hole. Turn the grommet several times to ensure it is properly seated.
3.Adjust stop pin to the height shown in Fig. 6. The pin height is determined by the length of the rod end which is to be installed into the grommet. If the pin height is not adjusted, the control rod may be pushed too far through the grommet, causing damage to the grommet retaining lip.
4.With the pin height properly adjusted, position the control rod on the tool and force the rod into the grommet until the groove in the rod seats on the inner retaining lip of the grommet. Ensure the rod protrudes through the grommet approximately 1/4 inch after installation.


This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20