Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



INSPECTION

{tag}838361148@


NOTE: Refer to the Exploded View Of Front Pump image when performing the following procedure.

1.Inspect all components for damage or scoring. Replace entire pump if any part is damaged or worn.
2.Inspect converter hub bushing, then replace if scored or worn. Stake bushing at notches.
3.Inspect converter hub seal. If damaged, remove with impact slide hammer and seal remover No. 1175-AC or equivalent. Install new seal with seal installer No. T63L-77837-A or equivalent.
4.Inspect stator input shaft bushings. If bushings are worn or scored, replace complete control body assembly.
5.Inspect all valve and plug bores for scoring and check all passages for obstructions.
6.Inspect mating surfaces for burrs and scoring. If necessary, use crocus cloth to polish components. Use caution to avoid rounding sharp edges of valves and plugs.
7.Inspect all springs for distortion. Ensure all valves and plugs fall freely from their bores.

INSPECTION

Exploded View Of Front PumpExploded View Of Front Pump



NOTE: Refer to the Exploded View Of Front Pump image when performing the following procedure.

1.Inspect all components for damage or scoring. Replace entire pump if any part is damaged or worn.
2.Inspect converter hub bushing, then replace if scored or worn. Stake bushing at notches.
3.Inspect converter hub seal. If damaged, remove with impact slide hammer and seal remover No. 1175-AC or equivalent. Install new seal with seal installer No. T63L-77837-A or equivalent.
4.Inspect stator input shaft bushings. If bushings are worn or scored, replace complete control body assembly.
5.Inspect all valve and plug bores for scoring and check all passages for obstructions.
6.Inspect mating surfaces for burrs and scoring. If necessary, use crocus cloth to polish components. Use caution to avoid rounding sharp edges of valves and plugs.
7.Inspect all springs for distortion. Ensure all valves and plugs fall freely from their bores.




This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20