Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



Disassemble

CAUTION: All parts must be handled carefully to avoid nicking or burring the bearing or mating surfaces. Lubricate all internal parts with clean automatic transmission fluid before assembling them. Do not use any other lubricants except on gaskets and thrust washers. These may be coated with petroleum jelly to facilitate assembly. Always use new gaskets and seals when assembling transmission.

{tag}834437681@


1.Remove snap ring and bushing from rear of low reverse hub.
2.Remove rollers from spring assembly, then remove spring assembly from hub.
3.Remove remaining snap ring from hub.

Assemble
1.Install snap ring in forward snap ring groove in hub, as shown in the One-Way Clutch Assembly image.
2.Position hub on bench with forward end down.
3.Install one-way clutch spring on top of snap ring.
4.Install a roller into each of spring assembly compartments.
5.Install bushing on top of spring assembly, then install snap ring.

Disassemble

CAUTION: All parts must be handled carefully to avoid nicking or burring the bearing or mating surfaces. Lubricate all internal parts with clean automatic transmission fluid before assembling them. Do not use any other lubricants except on gaskets and thrust washers. These may be coated with petroleum jelly to facilitate assembly. Always use new gaskets and seals when assembling transmission.

One-Way Clutch AssemblyOne-Way Clutch Assembly



1.Remove snap ring and bushing from rear of low reverse hub.
2.Remove rollers from spring assembly, then remove spring assembly from hub.
3.Remove remaining snap ring from hub.

Assemble
1.Install snap ring in forward snap ring groove in hub, as shown in the One-Way Clutch Assembly image.
2.Position hub on bench with forward end down.
3.Install one-way clutch spring on top of snap ring.
4.Install a roller into each of spring assembly compartments.
5.Install bushing on top of spring assembly, then install snap ring.




This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20