Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



{tag}766371779@

Tester Jacks
1.VPWR Pin Jacks (red): Vehicle Power (VPWR) test points for solenoid circuits.
2.Solenoid (TCC, EPC) Signal Line Pin Jacks (black): Signal line test points for solenoid circuits.
3.BAT + (red) and BAT - (black) Pin Jacks: Battery reference points when measuring circuits for shorts.
4.TOT Pin Jacks: Test points for transmission oil temperature sensor.
5.TSS Pin Jacks: Test points for transmission speed sensor.

Tester LEDs and Controls
1.Overlay and Cable Correctly installed LEDs: Only LEDs with symbol and cable correctly match.
2.Status LEDs: LED OFF when not activated by tester (solenoid not activated, open circuit or signal line short to ground). LED "GREEN" when activated by tester and current draw is correct. LED "RED" when activated by tester and current draw is excessive (short to Battery Positive Voltage [B+]). All LEDs light orange during On-Board Diagnostic.
3.Solenoid Activate Buttons: Energize respective solenoids during click testing and activate selected circuits during DRIVE mode testing.
4.Bench/Drive Switch: Selects operating mode, either BENCH or DRIVE.
5.Solenoid Select/Gear Select Switch: Has three functions:
-In BENCH MODE: acts as shift solenoid selector for click testing.
-In DRIVE MODE: acts as forward gear selector in place of vehicles powertrain control module controlled shifting. Hydraulic safety mechanisms and overrides are built into the transmission.
-In OHMS CHECK: allows you to measure ohms.

Rotunda Transmission Tester.Rotunda Transmission Tester.


Tester Jacks
1.VPWR Pin Jacks (red): Vehicle Power (VPWR) test points for solenoid circuits.
2.Solenoid (TCC, EPC) Signal Line Pin Jacks (black): Signal line test points for solenoid circuits.
3.BAT + (red) and BAT - (black) Pin Jacks: Battery reference points when measuring circuits for shorts.
4.TOT Pin Jacks: Test points for transmission oil temperature sensor.
5.TSS Pin Jacks: Test points for transmission speed sensor.

Tester LEDs and Controls
1.Overlay and Cable Correctly installed LEDs: Only LEDs with symbol and cable correctly match.
2.Status LEDs: LED OFF when not activated by tester (solenoid not activated, open circuit or signal line short to ground). LED "GREEN" when activated by tester and current draw is correct. LED "RED" when activated by tester and current draw is excessive (short to Battery Positive Voltage [B+]). All LEDs light orange during On-Board Diagnostic.
3.Solenoid Activate Buttons: Energize respective solenoids during click testing and activate selected circuits during DRIVE mode testing.
4.Bench/Drive Switch: Selects operating mode, either BENCH or DRIVE.
5.Solenoid Select/Gear Select Switch: Has three functions:
-In BENCH MODE: acts as shift solenoid selector for click testing.
-In DRIVE MODE: acts as forward gear selector in place of vehicles powertrain control module controlled shifting. Hydraulic safety mechanisms and overrides are built into the transmission.
-In OHMS CHECK: allows you to measure ohms.




This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20