Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



VERIFICATION OF CONDITION

NOTES:
This procedure provides information which must be used in both determining the actual cause of customer concerns and performing the appropriate service procedures.

The Rotunda Super Star II Tester 007-0041 B or equivalent must be used on fast mode to properly display the On-Board Diagnostic Codes.

1.Required equipment:
-Rotunda Transmission Tester 007-00850 or equivalent.
-Rotunda Super Star II Tester 007-0041 B or equivalent.
-Rotunda 73 Digital Multimeter 105-00051 or equivalent.
-Transmission Range (TR) Sensor Cable (Rotunda Manual Lever Position Sensor (MLPS) Cable) 007-00086, used with Transmission Tester 007-085C or equivalent.
-Rotunda EEC-IV 60-Pin Breakout Box 007-0033 or equivalent.

NOTE: Some E4OD transmission conditions may cause engine concerns. An electronic pressure control short circuit may cause alternate firing. The torque converter clutch not disengaging will stall the engine.

2.Determine customer concerns relative to vehicle usage:
-Hot or cold vehicle operating temperature
-Hot or cold ambient temperatures
-Type of terrain
-Vehicle loaded/unloaded
-City/highway driving

3.Fluid level and condition.

4.Road test vehicle to verify customer concern using the shift point test and torque converter clutch operation tests.

5.Inspect vehicle for non-Ford approved add-on devices such as:
-Air conditioning
-Generators (alternators)
-Engine turbos
-Cellular telephones
-Cruise controls
-CB radios
-Linear boosters
-Backup alarm signals
-Computers

These items, if not installed properly, will affect powertrain control module or transmission function. Pay particular attention to add-on wiring splices in the powertrain control module (PCM)( 1 2A650) harness or transmission wiring harness, abnormal tire size or axle ratio changes.

6.After a road test, with the vehicle warm and before disturbing any connectors, perform the Quick Test using Rotunda Super Star II Tester OO7-41B or equivalent.


This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20