Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



{tag}190798183@

REMOVAL:
1.Disconnect battery ground cables from both batteries.
2.Place a container under vehicle and drain fuel from fuel filter.
3.Remove water drain tube from bottom of filter assembly.
4.Unscrew water separator drain bowl and remove.
5.Unscrew fuel filter element.
6.Remove fuel heater.

INSTALLATION:
1.Install fuel heater.
2.Clean gasket surfaces of the fuel filter adapter to prevent contamination.
3.Lightly coat filter sealing gaskets with clean diesel fuel.

NOTE: To avoid fuel contamination do not add fuel directly to new filter. Allow engine to draw fuel through filter.

4.Screw new filter element onto filter base until seal contacts flange.
5.Tighten filter another 180 to 300°.
6.Install water separator drain bowl. Tighten another 180 to 300°.
7.Install water drain tube.
8.Clean up any spilled fuel from top of engine.
9.Connect battery ground cables to both batteries.
10.Run engine and check for fuel leaks.


Fuel Filter/Fuel Heater/Water SeparatorFuel Filter/Fuel Heater/Water Separator


REMOVAL:
1.Disconnect battery ground cables from both batteries.
2.Place a container under vehicle and drain fuel from fuel filter.
3.Remove water drain tube from bottom of filter assembly.
4.Unscrew water separator drain bowl and remove.
5.Unscrew fuel filter element.
6.Remove fuel heater.

INSTALLATION:
1.Install fuel heater.
2.Clean gasket surfaces of the fuel filter adapter to prevent contamination.
3.Lightly coat filter sealing gaskets with clean diesel fuel.

NOTE: To avoid fuel contamination do not add fuel directly to new filter. Allow engine to draw fuel through filter.

4.Screw new filter element onto filter base until seal contacts flange.
5.Tighten filter another 180 to 300°.
6.Install water separator drain bowl. Tighten another 180 to 300°.
7.Install water drain tube.
8.Clean up any spilled fuel from top of engine.
9.Connect battery ground cables to both batteries.
10.Run engine and check for fuel leaks.





This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20