Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



1.Ensure self test is DEACTIVATED, then START and run the engine at 2,000 rpm for two minutes.
NOTE: IF the engine starts but stalls, or stalls during self test, refer to pinpoint test step S2.

2.Turn the engine OFF and wait for ten seconds.
3.ACTIVATE the self test by grounding the STI connector.

{tag}456825215@

4.Start the engine.
5.After the engine ID code, depress and release the brake pedal, then turn the steering wheel 1/2 turn and release it. If the vehicle is equipped with an E4OD transmission cycle the Overdrive Cancel Switch (OCS).
6.If the dynamic response "goose" code appears, briefly go to wide open throttle.
7.Record all codes displayed.
NOTE: Engine running service code 98/998 indicates vehicle is in Failure Mode Effects Management (FMEM) and DID NOT PASS the Key ON Engine OFF (KOEO) on demand/continuous memory self test. Engine running self test cannot be performed while in FMEM. Rerun KOEO self test and correct all fault codes.
8.Turn OFF the engine and DEACTIVATE the self test.
9.If a pass code (11) was received in the KOER test, proceed with the next step.
If any other codes are received, refer to the proper diagnostic trouble code chart for the diagnostic path.
1.Ensure self test is DEACTIVATED, then START and run the engine at 2,000 rpm for two minutes.
NOTE: IF the engine starts but stalls, or stalls during self test, refer to pinpoint test step S2.

2.Turn the engine OFF and wait for ten seconds.
3.ACTIVATE the self test by grounding the STI connector.

Jumper Wire Installed Between Pin 2 And Self Test Input (STI)Jumper Wire Installed Between Pin 2 And Self Test Input (STI)


4.Start the engine.
5.After the engine ID code, depress and release the brake pedal, then turn the steering wheel 1/2 turn and release it. If the vehicle is equipped with an E4OD transmission cycle the Overdrive Cancel Switch (OCS).
6.If the dynamic response "goose" code appears, briefly go to wide open throttle.
7.Record all codes displayed.
NOTE: Engine running service code 98/998 indicates vehicle is in Failure Mode Effects Management (FMEM) and DID NOT PASS the Key ON Engine OFF (KOEO) on demand/continuous memory self test. Engine running self test cannot be performed while in FMEM. Rerun KOEO self test and correct all fault codes.
8.Turn OFF the engine and DEACTIVATE the self test.
9.If a pass code (11) was received in the KOER test, proceed with the next step.
If any other codes are received, refer to the proper diagnostic trouble code chart for the diagnostic path.



This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20