Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



NOTE: Using this procedure, the technician can attempt to recreate and detect an intermittent fault.

KEY ON ENGINE OFF

1.Ensure the ignition switch is in the OFF position.
2.Turn the ignition key to the ON position.

{tag}456825215@

3.ACTIVATE, DEACTIVATE, and REACTIVATE the self-test by grounding, ungrounding, and re-grounding the STI connector. You are now in the wiggle test mode.
4.Tap, move, and wiggle the suspected circuits sensors and wiring. When a fault is detected, PCM will set a code and signal a fault by flashing the CHECK ENGINE light.
NOTE: If any codes are set, perform the appropriate pinpoint test.
5.To exit the wiggle test mode, DEACTIVATE the self test and turn the key OFF.

KEY ON ENGINE RUNNING

NOTE: The Key On Engine Running (KOER) wiggle test may be entered any time the engine is running.

1.Ensure the ignition switch is in the OFF position.
2.START the engine, then ACTIVATE, DEACTIVATE, and REACTIVATE the self test. You are now in the engine running wiggle test mode.
NOTE: Do not turn the engine OFF.
3.Tap, move, and wiggle the suspected circuits sensors and wiring. When a fault is detected, PCM will set a code and signal a fault.
NOTE: If any codes are set, perform the appropriate pinpoint test.
4.To exit the wiggle test mode, DEACTIVATE the self test and turn the key OFF.NOTE: Using this procedure, the technician can attempt to recreate and detect an intermittent fault.

KEY ON ENGINE OFF

1.Ensure the ignition switch is in the OFF position.
2.Turn the ignition key to the ON position.

Jumper Wire Installed Between Pin 2 And Self Test Input (STI)Jumper Wire Installed Between Pin 2 And Self Test Input (STI)


3.ACTIVATE, DEACTIVATE, and REACTIVATE the self-test by grounding, ungrounding, and re-grounding the STI connector. You are now in the wiggle test mode.
4.Tap, move, and wiggle the suspected circuits sensors and wiring. When a fault is detected, PCM will set a code and signal a fault by flashing the CHECK ENGINE light.
NOTE: If any codes are set, perform the appropriate pinpoint test.
5.To exit the wiggle test mode, DEACTIVATE the self test and turn the key OFF.

KEY ON ENGINE RUNNING

NOTE: The Key On Engine Running (KOER) wiggle test may be entered any time the engine is running.

1.Ensure the ignition switch is in the OFF position.
2.START the engine, then ACTIVATE, DEACTIVATE, and REACTIVATE the self test. You are now in the engine running wiggle test mode.
NOTE: Do not turn the engine OFF.
3.Tap, move, and wiggle the suspected circuits sensors and wiring. When a fault is detected, PCM will set a code and signal a fault.
NOTE: If any codes are set, perform the appropriate pinpoint test.
4.To exit the wiggle test mode, DEACTIVATE the self test and turn the key OFF.


This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20