Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



STATIC DISCHARGE

1.Discharge any static electrical charges before handling electronic parts by touching ground or maintaining a ground connection to a bare skin area like the wrist.
2.Never touch the Powertrain Control Module (PCM) connector pins, integrated circuit connector pins, or soldered components on the PCM circuit board.

TESTING

1.When measuring voltage at the PCM harness connector, disconnect harness connector with the ignition OFF, then turn ignition "ON" as necessary.
2.To prevent deforming PCM harness connectors, do not probe terminals directly. Instead, insert a pin from the harness side and perform measurements through pin.

ELECTRONIC CONTROL UNIT DAMAGE

1.Do not try to disassemble any PCM.
2.Before performing electrical welding (for instance, spot welding), disconnect the battery, climate control, cruise control, PCM and radio.
3.If temperatures may exceed 176°F (80°C), (example: infra-red spray booth), remove all PCMs.
4.Avoid getting water on any of the Fuel and Electronic Control System Components.
5.Never apply battery power to a component unless directed to do so in a test procedure.






This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20