Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



1.Disconnect battery ground cables from both batteries and remove hood.
2.Drain cooling system, then remove air cleaner and intake duct assembly.
3.Place a suitable cover over intake manifold opening.
4.Remove fan shroud, then the fan and clutch assembly. The fan retaining nut has lefthand threads.
5.Disconnect upper and lower hoses and the automatic transmission cooler lines from radiator.
6.Remove radiator.
7.On models equipped with A/C, remove A/C compressor drive belt, then remove and position compressor on radiator upper support.
8.On all models, remove power steering pump drive belt and remove and position pump aside.
9.Disconnect fuel supply line heater and alternator wiring from alternator.
10.Remove oil pressure sender from firewall and lay sender on engine.
11.Disconnect accelerator cable and speed control cable, if equipped, from injection pump.
12.Remove accelerator cable bracket, with cables, from intake manifold and position aside.
13.If equipped, disconnect transmission kickdown rod from injection pump.
14.Disconnect main wiring harness connector from right side of engine.
15.Disconnect ground strap from rear of engine.
16.Disconnect fuel return hose from left rear of engine.
17.Remove two upper engine to transmission attaching bolts.
18.Disconnect heater hoses from water pump and righthand cylinder head.
19.Disconnect water temperature sender wiring from left front of cylinder block.
20.Disconnect water temperature overheat light switch from top front of lefthand cylinder head.
21.Raise and support vehicle.
22.Disconnect battery ground cables from lower front of engine and remove from vehicle.
23.Disconnect and plug fuel inlet line from supply pump.
24.Disconnect starter motor wiring.
25.Disconnect exhaust pipe from exhaust manifold.
26.Remove bolts attaching front engine mounts from front crossmember.
27.Remove flywheel cover, then the converter to flywheel attaching nuts.
28.Lower vehicle and support transmission with a suitable jack.
29.Remove four transmission to engine attaching bolts.
30.Attach suitable engine lifting equipment to engine and raise engine slightly to clear the front crossmember and pull engine forward. Move front of engine approximately 45° toward the left side of engine compartment, then lift engine from vehicle. Use care not to damage the wiper motor when removing engine.
31.Reverse procedure to install.


This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20