Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



Be sure the bleeder tank contains enough of the specified brake fluid to complete the bleeding operation. Charge the tank with approximately 69-206 kPa (10-30 psi). Never exceed 345 kPa (50 psi). Never use brake fluid that has been drained from the hydraulic system. Bleed the longest lines first

1.Clean all dirt from the master cylinder reservoir cap.

2.Remove the master cylinder reservoir cap and fill the master cylinder reservoir with the specified brake fluid. Install the pressure bleeder adapter tool on the master cylinder, and attach the bleeder tank hose to the fitting on the adapter.

NOTE: Master cylinder pressure bleeder adapter tools are available from the manufacturers of pressure bleeding equipment. Follow the manufacturers instructions when installing the adapter.

3.Place a 3/8 inch box wrench on the bleeder fitting on the right rear brake wheel cylinder. Attach a bleeder tube snugly to the bleeder fitting.

4.Open the valve on the bleeder tank and admit pressurized brake fluid to the master cylinder reservoir.

5.Submerge the free end of the tube in a container partially filled with clean brake fluid, and loosen the bleeder fitting.

6.When air bubbles no longer appear in the fluid at the submerged end of the bleeder tube, close the bleeder fitting and remove the tube.

7.Repeat Steps 3 through 6 at the opposite wheel cylinder. On front brakes, bleed the right front caliper first.

8.When the bleeding operation is completed, close the bleeder tank valve and remove the tank hose from the adapter fitting.

9.Remove the pressure bleeder adapter tool. Fill the master cylinder reservoirs with the specified brake fluid to within 3 mm (1/8 in) from the top of the filler neck. Install the master cylinder cover.



This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20