Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



NOTE: Bleed primary and secondary hydraulic brake systems separately, bleeding longest line first on each system. Do not allow reservoir to run dry during bleeding operation. Never reuse fluid that has been drained from hydraulic system.

1.Loosen master cylinder to hydraulic line nuts and wrap shop cloths around tubing below fitting to absorb escaping brake fluid.

2.Depress brake pedal slowly forcing air trapped in master cylinder out at fitting.

3.Hold pedal down and tighten fittings, then release brake pedal.

NOTE: Releasing brake pedal before fittings are tightened will allow air to enter the master cylinder.

4.Repeat steps 1 through 3 until air ceases to escape at fittings and brake pedal is firm.

5.Bleed brakes as follows:

RR, LR, ABS valve, RF, LF

a.Pump pedal several times, then hold pedal down firmly.

b.With pedal firmly depressed, open bleeder screw on one rear brake until pedal fades, then close bleeder valve.

c.Repeat procedure until a continuous flow of brake fluid is released from bleeder valve.

d.Repeat steps 5a through 5c on other rear brake.

6.Bleed the Rear Antilock Brake System (RABS) valve.

7.Bleed the front brakes using same procedure as for rear brakes.

8.Check brake operation and ensure pedal is firm, road test vehicle.

For additional information Fundamentals and Basics.


This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20