Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



To program (or re-program) transmitter(s) into the electronic door lock control, perform the following steps:

1.Turn the ignition switch to the ON or ON/ACC position and short the two terminals of the program connector (J2), a two-pin connector located below the drivers side of the instrument panel at the base of the steering column. All doors should lock and then unlock.
2.Press any button on each transmitter, (one at a time). All doors should lock and then unlock. If the door locks do not respond, press the button again (up to three times maximum with the same transmitter). If the door locks still fail to respond, go to PINPOINT TEST D.
3.Repeat Step 2 to program additional transmitters into the control module (up to four transmitters maximum).
4.Turn ignition switch off. All doors should lock and then unlock.
5.Make sure the short has been removed from the program connector J2.

If the customer has purchased additional transmitters or lost a transmitter, or if the transmitter must be re-programmed into the processor, all the customers transmitters must be available for reprogramming at the same time.



This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20