Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



Lap Belt Retractor Test-(Two-Point System)
Grasp the new seat belt tongue and pull the webbing out of the retractor until the manufacturers label is exposed. Return approximately 127 mm (5 inches) of webbing into the retractor and pull. If the retractor locks, the belt assembly is functioning properly. If the retractor does not lock or the webbing cannot be pulled from the retractor far enough to expose the manufacturers identification label, rework the sheet metal surface in the seat belt retractor attaching area until the retractor will function properly.

WARNING: IF THE RETRACTOR OF A NEW SEAT BELT ASSEMBLY HAS BEEN BOLTED INTO A DAMAGED OR DISTORTED MOUNTING AREA, THE NEW RETRACTOR COULD BE WARPED AND MAY NOT FUNCTION. IF THIS IS THE CASE, RESHAPE THE SHEET METAL AND INSTALL ANOTHER NEW COMPLETE SEAT BELT ASSEMBLY.

Continuous Loop Shoulder/Lap Belt Test- (System with Movable Tongue and One Retractor)
1.Driver will buckle up and proceed to a safe test area. If the RH passenger seat belt must be tested, a passenger should be buckled into the RH seat. (The passenger belt may be tested utilizing a driver only, providing the driver has the ability to grasp the RH shoulder belt and extend it approximately 660.4 mm (26 inches) with no compromise to safe driving.) This method applies to the 8.05 km/h (5 mph) test only.

NOTE: The RH shoulder belt is not extended fully to preclude the possibility of a false feeling (full extension vs. lock-up).

2.After reaching a safe area to perform sudden stops, the driver will attain a speed of approximately 8 km/h (5 mph). The driver Should inform the passenger, if applicable, that he is preparing to make a severe brake application. At this time, both driver and rider should grasp their respective shoulder harness and prepare to lean slightly forward at the moment the brake application is made.
3.The driver will make a maximum brake application (approximately 9.7 m/sq.sec (32 ft/sq.sec)) without tire skid. (The maximum brake application should be on dry concrete or equivalent hard road surface. Never on a wet or gravel road.) The driver and passenger should lean forward slightly into the shoulder harness. At this instant, the belts should lock up without webbing payout.

WARNING: THE DRIVER AND PASSENGER SHOULD BE PREPARED TO BRACE THEMSELVES IN THE EVENT THE SEAT BELT RETRACTOR DOES NOT LOCK.

4.If there is a lock-up of both shoulder straps, the seat belt assemblies are functioning properly. Should either or both retractors fail to lock up at the 8.05 km/h (5 mph) speed, the test should be repeated at a constant 24.14 km/h (15 mph). (This test must be performed with a RH passenger if the RH belt is to be tested.)
5.If either or both shoulder belts do not lock up at the 24.14 km/h (15 mph) test, the vehicle is to be returned for repair of the malfunctioning seat belts. Remove the retractor and rework the sheet metal in the retractors mounting surface. Install the retractor assembly and test the seat belt assembly(s) as previously stated.

WARNING: IF THE RETRACTOR OF A NEW SEAT BELT ASSEMBLY HAS BEEN BOLTED INTO A DAMAGED OR DISTORTED MOUNTING AREA, THE NEW RETRACTOR COULD BE WARPED AND MAY NOT FUNCTION. IF THIS IS THE CASE, RESHAPE THE SHEET METAL AND INSTALL ANOTHER NEW COMPLETE SEAT BELT ASSEMBLY.



This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20