Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



{tag}1246373563@

1.Remove valve sleeve rings, Fig. 2, from sleeve by inserting the blade of a small pocket knife carefully under them and cutting them off, without scratching the valve sleeve.
2.With the worm end of the worm and valve sleeve assembly mounted into a soft-jawed vise, install mandrel tool T75L-3517-A1 over the sleeve and slide one valve sleeve ring over the tool.
3.Slide the pusher tool T75L-3517-A2 over the mandrel then rapidly push down on the pusher tool, forcing the ring down the ramp and into the fourth groove of the valve sleeve. Repeat this step three more times, each time adding one of the spacers, tool T75L-3517-A3, under the mandrel tool. Adding the spacer each time will align the mandrel tool with the next groove of the valve sleeve.
4.After installing all four valve sleeve rings, apply a light coat of gear lubricant to the sleeve and rings.
5.Slowly install the sizing tube tool T75L-3517-A4, over the sleeve valve end of the worm shaft and onto the valve sleeve rings. Make sure that the rings turn freely in the grooves.



Fig. 2 Ball & nut valve housing disassembledFig. 2 Ball & nut valve housing disassembled


1.Remove valve sleeve rings, Fig. 2, from sleeve by inserting the blade of a small pocket knife carefully under them and cutting them off, without scratching the valve sleeve.
2.With the worm end of the worm and valve sleeve assembly mounted into a soft-jawed vise, install mandrel tool T75L-3517-A1 over the sleeve and slide one valve sleeve ring over the tool.
3.Slide the pusher tool T75L-3517-A2 over the mandrel then rapidly push down on the pusher tool, forcing the ring down the ramp and into the fourth groove of the valve sleeve. Repeat this step three more times, each time adding one of the spacers, tool T75L-3517-A3, under the mandrel tool. Adding the spacer each time will align the mandrel tool with the next groove of the valve sleeve.
4.After installing all four valve sleeve rings, apply a light coat of gear lubricant to the sleeve and rings.
5.Slowly install the sizing tube tool T75L-3517-A4, over the sleeve valve end of the worm shaft and onto the valve sleeve rings. Make sure that the rings turn freely in the grooves.






This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20