Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



{tag}1247016111@




1.Referring to Fig. 4, remove dust seal and snap ring.
2.Invert housing and from opposite seal end, gently tap bearing and seal out of housing. Exercise care when inserting and removing tool to prevent damage to valve bore in housing.
3.Remove oil inlet and outlet tube seats with ``EZ-Out if damaged.
4.Coat tube seats with petroleum jelly and position them in housing. Install and tighten tube nuts to press seats to proper location.
5.Coat bearing and seal surface in housing with a film of petroleum jelly.
6.Position bearing in valve housing. Seat bearing in housing with bearing installation tool No. T65P-3524-A1, or equivalent ensuring that bearing rotates freely.
7.Dip new oil seal in gear lube. Then position seal facing outward. Drive seal into housing until outer edge of seal does not quite clear snap ring.
8.Place snap ring in housing. Then drive on ring with bearing remover tool No. T65P-3524-A1 until snap ring seats in its groove to locate seal properly.
9.Place dust seal in housing with dished side (rubber side) facing out. Drive dust seal in place so that it is located behind undercut in input shaft when it is installed.Fig. 4 Valve HousingFig. 4 Valve Housing





1.Referring to Fig. 4, remove dust seal and snap ring.
2.Invert housing and from opposite seal end, gently tap bearing and seal out of housing. Exercise care when inserting and removing tool to prevent damage to valve bore in housing.
3.Remove oil inlet and outlet tube seats with ``EZ-Out if damaged.
4.Coat tube seats with petroleum jelly and position them in housing. Install and tighten tube nuts to press seats to proper location.
5.Coat bearing and seal surface in housing with a film of petroleum jelly.
6.Position bearing in valve housing. Seat bearing in housing with bearing installation tool No. T65P-3524-A1, or equivalent ensuring that bearing rotates freely.
7.Dip new oil seal in gear lube. Then position seal facing outward. Drive seal into housing until outer edge of seal does not quite clear snap ring.
8.Place snap ring in housing. Then drive on ring with bearing remover tool No. T65P-3524-A1 until snap ring seats in its groove to locate seal properly.
9.Place dust seal in housing with dished side (rubber side) facing out. Drive dust seal in place so that it is located behind undercut in input shaft when it is installed.


This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20