Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



1.Install a 2000 psi pressure gauge in pressure line between pump outlet port and steering gear inlet port. Make sure that valve on gauge is in fully open position.
2.Check fluid level in reservoir and replenish as required.
3.Start engine and cycle steering wheel from stop-to-stop to bring steering lubricant up to normal operating temperature. Stop engine and recheck reservoir. Add fluid as necessary.
4.With engine running at a fast idle speed (1000 RPM) and steering wheel centered, attach an inch-pound torque wrench to steering wheel retaining nut. Apply sufficient torque to wrench in each direction (either side of center) to get a gauge reading of 250 psi.
5.Torque reading should be the same in both directions. If difference between readings exceeds 6 inch lbs., remove steering gear from vehicle and replace shaft and control assembly. The ``out-of-vehicle procedure for centering check is the same as for the ``in-vehicle except torque and simultaneous pressure reading must be made at right and left stops instead of either side of center.


This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20