Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



NOTE: The following procedure applies to vehicle that have functional lock cylinders. Lock cylinder keys are available for these vehicles, or the lock cylinder key numbers are known and the proper key can be made.

Removal
1.Disconnect battery ground cable.
2.Turn lock cylinder key to RUN position.

{tag}1185493542@

3.Place a 3.17 mm (1/8 inch) diameter wire pin or small drift punch in hole in trim shroud under lock cylinder. Depress retaining pin while pulling out on lock cylinder to remove it from column housing.

Installation
1.Install lock cylinder by turning it to RUN position and depressing retaining pin. Insert lock cylinder into lock cylinder housing. Make sure cylinder is fully seated and aligned in interlocking washer before turning key to OFF position. This will permit cylinder retaining pin to extend into cylinder housing hole.
2.ROTATE lock cylinder. using lock cylinder key, to ensure correct mechanical operation in all positions.
3.Connect battery ground cable.

NOTE: On vehicles equipped with Powertrain Control Module (PCM), when the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the PCM processor relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.
NOTE: The following procedure applies to vehicle that have functional lock cylinders. Lock cylinder keys are available for these vehicles, or the lock cylinder key numbers are known and the proper key can be made.

Removal
1.Disconnect battery ground cable.
2.Turn lock cylinder key to RUN position.

Removing Lock CylinderRemoving Lock Cylinder


3.Place a 3.17 mm (1/8 inch) diameter wire pin or small drift punch in hole in trim shroud under lock cylinder. Depress retaining pin while pulling out on lock cylinder to remove it from column housing.

Installation
1.Install lock cylinder by turning it to RUN position and depressing retaining pin. Insert lock cylinder into lock cylinder housing. Make sure cylinder is fully seated and aligned in interlocking washer before turning key to OFF position. This will permit cylinder retaining pin to extend into cylinder housing hole.
2.ROTATE lock cylinder. using lock cylinder key, to ensure correct mechanical operation in all positions.
3.Connect battery ground cable.

NOTE: On vehicles equipped with Powertrain Control Module (PCM), when the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the PCM processor relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.



This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20