Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



I and S Circuits

{tag}1177078765@

1.Disconnect the wiring plug from the regulator. Connect a jumper wire from the regulator A terminal to the wiring plug A lead. Add a jumper wire from the regulator F screw to the alternator rear housing.
2.With the engine idling and the voltmeter negative lead connected to the battery ground terminal, connect the voltmeter positive lead to the S terminal and then to the I terminal of the regulator wiring plug. The voltage at the S circuit should read approximately one-half that of the I circuit. If voltage readings are normal, remove the jumper wires. Replace the regulator and connect the wiring plug to the regulator. Repeat the load test.
3.If no voltage is present, remove the jumper wires and service the faulty wiring circuit or alternator.
4.Connect the voltmeter positive lead to the positive battery terminal. Connect the wiring plug to the regulator. Repeat the load test.




I and S Circuits

Jumper WiresJumper Wires


1.Disconnect the wiring plug from the regulator. Connect a jumper wire from the regulator A terminal to the wiring plug A lead. Add a jumper wire from the regulator F screw to the alternator rear housing.
2.With the engine idling and the voltmeter negative lead connected to the battery ground terminal, connect the voltmeter positive lead to the S terminal and then to the I terminal of the regulator wiring plug. The voltage at the S circuit should read approximately one-half that of the I circuit. If voltage readings are normal, remove the jumper wires. Replace the regulator and connect the wiring plug to the regulator. Repeat the load test.
3.If no voltage is present, remove the jumper wires and service the faulty wiring circuit or alternator.
4.Connect the voltmeter positive lead to the positive battery terminal. Connect the wiring plug to the regulator. Repeat the load test.







This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20