Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



DISASSEMBLE
Position two collet halves (44803 and 44797) of universal bearing remover set tool No. D81L-4220A or equivalent, around input shaft bearing cone, then install pulling tube assembly on collet halves and pull input shaft bearing from input shaft.

ASSEMBLE
1.Inspect surface of input shaft in area of bearing race to ensure it is smooth and free of burrs.
2.Inspect condition of guide splines.
3.Place bearing on input shaft, then the bearing cone replacer tool No. T85T-4621-AH over bearing.

{tag}1033570748@


4.Position shaft, bearing and bearing cone replacer in press plates tool No. T75L-1165-B as shown in the Input Shaft Bearing Removal image.

NOTE: An alternate method to the previous step is to heat input shaft tapered roller bearing inner race to approximately 320° F, using a suitable gear heater. Ensure not to heat race for more than 15 minutes.

5.Install inner race, then if necessary seat race using a suitable tool. If necessary to drive bearing on, ensure to drive against inner race and not against bearing cone.




DISASSEMBLE
Position two collet halves (44803 and 44797) of universal bearing remover set tool No. D81L-4220A or equivalent, around input shaft bearing cone, then install pulling tube assembly on collet halves and pull input shaft bearing from input shaft.

ASSEMBLE
1.Inspect surface of input shaft in area of bearing race to ensure it is smooth and free of burrs.
2.Inspect condition of guide splines.
3.Place bearing on input shaft, then the bearing cone replacer tool No. T85T-4621-AH over bearing.

Input Shaft Bearing RemovalInput Shaft Bearing Removal



4.Position shaft, bearing and bearing cone replacer in press plates tool No. T75L-1165-B as shown in the Input Shaft Bearing Removal image.

NOTE: An alternate method to the previous step is to heat input shaft tapered roller bearing inner race to approximately 320° F, using a suitable gear heater. Ensure not to heat race for more than 15 minutes.

5.Install inner race, then if necessary seat race using a suitable tool. If necessary to drive bearing on, ensure to drive against inner race and not against bearing cone.







This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20