Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



OIL SEAL AND WHEEL BEARING



1.Remove axle shaft as outlined under REAR AXLE SHAFT.
2.Insert tool T83T-1226-A for models with 8.8 inch ring gear, or tool T85T-1225-AH for models with 10.25 inch ring gear, and tool T50T-100-A into axle bore so tangs on tool engage bearing outer race. Remove bearing and seal as an assembly.
3.Install new bearing using tool T83T-1225-B on models with 8.8 inch ring gear, or tool T80T-4000-W on models with 10.25 inch ring gear, and new seal using tool T83T-1175-A on models with 8.8 inch ring gear, or tool T80T-4000-Y on models with 10.25 inch ring gear. Pack lips of seal with C1AZ-19590-B or equivalent.
4.Reinstall axle.


REAR AXLE SHAFT


1.Raise and support vehicle, then remove rear wheel and brake drum.
2.Loosen rear housing cover screws and allow lubricant to drain, then remove cover.
3.Remove differential pinion shaft lock bolt and differential pinion shaft.
4.Move flanged end of axle shaft inward and remove C-lock from end of shaft.
5.Remove axle shaft from housing by pulling outward.
6.Reverse procedure to install. Apply Loctite EOAZ-19554-B to pinion shaft lock bolt threads, then tighten lock bolt to specifications.


This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20