Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



Removal, Units w/Ball Bearing

1.Remove wheel assembly.
2.Remove brake drum from flange.
3.Working through hole provided in axle shaft flange, remove nuts that secure wheel bearing retainer.
4.Pull axle shaft out of housing. If bearing is a tight fit in axle housing, use a slide hammer type puller.
5.Remove brake backing plate and secure to frame rail.
6.If the axle shaft bearing is to be replaced, loosen the inner retainer by nicking it deeply with a chisel in several places. The bearing will then slide off easily.
7.Press bearing from axle shaft.
8.Inspect machined surface of axle shaft and housing for rough spots that would affect sealing action of the oil seal. Carefully remove any burrs or rough spots.

Installation

1.Press new bearing on shaft until it seats firmly against shoulder on shaft.
2.Press inner bearing retainer on shaft until it seats firmly against bearing.
3.If oil seal is to be replaced, use a hook-type tool to pull it out of housing. Wipe a small amount of oil resistant sealer on outer edge of seal before it is installed.

Removal, Units w/Roller Bearing

1.Remove wheel assembly.
2.Remove brake drum from flange.
3.Working through hole provided in axle flange, remove nuts securing wheel bearing retainer.
4.Pull axle shaft carefully from housing to prevent damage to outer seal rubber. Use a slide hammer type puller to remove tapered bearing cup from housing. Remove brake backing plate and secure to frame rail.
5.If the axle shaft bearing or seal is to be replaced, split the inner bearing retainer.
6.Press bearing from axle shaft.
7.Inspect machined surface of axle shaft and housing for rough spots that would affect sealing action of the oil seal. Carefully remove any burrs or rough spots.
8.Install outer retainer plate on axle shaft. Press lubricated seal and bearing onto shaft until firmly seated. Oil seal for rear drum brake equipped vehicles is different than that used on vehicles with rear disc brakes. Seals used with drum brakes have a gray metal colored outer rim, while seals used with disc brakes have a black or orange color.
9.Press new bearing retainer onto shaft until seated.

Installation

1.On models with roller bearing, ensure outer seal is fully seated on bearing.
2.On all models, start splines into differential side gear and push shaft in until bearing bottoms in housing.
3.Tighten bearing retainer nuts to specifications.


This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20