Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



1.Assemble preload shims and slinger, if applicable, onto pinion, then install pinion gear into carrier housing.
2.Install outer pinion bearing and oil slinger, if applicable.
3.Install end yoke or flange, washer and new pinion nut on pinion shaft and torque to specifications.
4.Place an inch-pound torque wrench on pinion nut and check pinion rotational torque. Rotational torque should be 20-40 inch lbs.
5.To increase preload, remove shims. To decrease preload, add shims.
6.With drive pinion at correct preload, remove pinion nut, washer and end yoke or flange.
7.Coat drive pinion oil seal with suitable hypoid gear lubricant or equivalent, then install drive pinion oil seal using suitable oil seal replacer. After installation, ensure garter spring did not pop out. If garter spring pops out, remove and replace seal.
8.Install end yoke or flange with a suitable pinion flange replacer, then the washer and nut and torque to specifications.



This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20