Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



Removal
1.Disconnect battery ground cable.
2.Pull wiring harness connector from the sensor, mounted in the rear axle housing.
3.Remove sensor hold-down bolt and remove sensor from axle housing.
Installation
1.Clean axle mounting surface. Use care to prevent dirt from entering axle housing.
2.Inspect and clean magnetized sensor pole piece to ensure it is free from loose metal particles which could cause erratic system operation.
3.Inspect sensor O-ring for damage. Replace if necessary.
4.Lightly lubricate the sensor O-ring with clean motor oil. align sensor bolt hole and install sensor. Do not apply force to plastic sensor connector.
5.Sensor flange should slide to the mounting surface. This will ensure the air gap setting is between .005---.045 inches.
6.Install hold-down bolt and torque to 25---30 ft. lbs.
7.Push electrical connector onto sensor.



This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20