Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



NOTE: Always drive the vehicle in a safe manner according to driving conditions and obey all traffic laws.

NOTE: The Transmission Cycle Test must be followed exactly. Malfunctions must occur four times consecutively for the shift error DTC code to be set and five times consecutively the for continuous torque converter clutch code to set.

{tag}745161404@

NOTE: When performing the Transmission Drive Cycle Test refer to the Solenoid Operation Chart for proper solenoid operation.

After performing the Quick Test, use the Transmission Drive Cycle Test for checking continuous codes.

1.Record and then erase the Quick Test codes.
2.Warm the engine to normal operating temperature.
3.Make sure the transmission fluid level is correct.
4.With the transmission in OVERDRIVE, moderately accelerate from stop to 80 km/h (50 mph). This allows the transmission to shift into fourth gear. Hold speed and throttle open steady for a minimum of 15 seconds.
5.With transmission in OVERDRIVE, press Transmission Control Switch (TCS) (Transmission Control Illuminator Lamp (TCIL) should illuminate) and moderately accelerate from stop to 64 km/h (40 mph). This allows the transmission to shift into third gear. Hold speed and throttle open steady for a minimum of 15 seconds (30 seconds above 4000 ft altitude).
6.Press TCS (TCIL should turn off) and accelerate from 64 km/h (40 mph) to 80 km/h (50 mph). This allows transmission to shift into fourth gear. Hold speed and throttle position steady for a minimum of 15 seconds.
7.With transmission in fourth gear and maintaining steady speed and throttle opening, lightly apply and release brake to operate stoplamps. Then hold speed and throttle steady for an additional 5 seconds (minimum).
8.Brake to a stop and remain stopped for a minimum of 20 seconds.
9.Repeat Steps 4 through 8 at least five times.
10.Perform Quick Test and record continuous codes.

NOTE: Always drive the vehicle in a safe manner according to driving conditions and obey all traffic laws.

NOTE: The Transmission Cycle Test must be followed exactly. Malfunctions must occur four times consecutively for the shift error DTC code to be set and five times consecutively the for continuous torque converter clutch code to set.

Solenoid Operation ChartSolenoid Operation Chart


NOTE: When performing the Transmission Drive Cycle Test refer to the Solenoid Operation Chart for proper solenoid operation.

After performing the Quick Test, use the Transmission Drive Cycle Test for checking continuous codes.

1.Record and then erase the Quick Test codes.
2.Warm the engine to normal operating temperature.
3.Make sure the transmission fluid level is correct.
4.With the transmission in OVERDRIVE, moderately accelerate from stop to 80 km/h (50 mph). This allows the transmission to shift into fourth gear. Hold speed and throttle open steady for a minimum of 15 seconds.
5.With transmission in OVERDRIVE, press Transmission Control Switch (TCS) (Transmission Control Illuminator Lamp (TCIL) should illuminate) and moderately accelerate from stop to 64 km/h (40 mph). This allows the transmission to shift into third gear. Hold speed and throttle open steady for a minimum of 15 seconds (30 seconds above 4000 ft altitude).
6.Press TCS (TCIL should turn off) and accelerate from 64 km/h (40 mph) to 80 km/h (50 mph). This allows transmission to shift into fourth gear. Hold speed and throttle position steady for a minimum of 15 seconds.
7.With transmission in fourth gear and maintaining steady speed and throttle opening, lightly apply and release brake to operate stoplamps. Then hold speed and throttle steady for an additional 5 seconds (minimum).
8.Brake to a stop and remain stopped for a minimum of 20 seconds.
9.Repeat Steps 4 through 8 at least five times.
10.Perform Quick Test and record continuous codes.




This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20