Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



Deactivation Procedure
1.Disconnect the battery ground cable.

WARNING: THE BACKUP POWER SUPPLY ENERGY MUST BE DEPLETED BEFORE ANY AIR BAG COMPONENT REPAIR IS PERFORMED. TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND WAIT ONE MINUTE TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

2.Wait one minute for the backup power supply in the air bag diagnostic monitor to deplete its stored energy.
3.Remove the driver side air bag module from the vehicle.

WARNING: PLACE THE AIR BAG MODULE ON A BENCH WITH THE TRIM COVER FACING UP TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

4.Connect the air bag simulator to the vehicle harness at the top of the steering column.
5.Remove the passenger side air bag module from the vehicle.

WARNING: PLACE THE AIR BAG MODULE ON A BENCH WITH THE DEPLOYMENT DOOR FACING UP TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

6.Connect the air bag simulator to the vehicle harness.
7.Reconnect the battery ground cable.

NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

Reactivation Procedure
1.Disconnect the battery ground cable.

WARNING: THE AIR BAG SIMULATORS MUST BE REMOVED AND THE AIR BAG MODULES RECONNECTED WHEN THE SYSTEM IS REACTIVATED TO AVOID NON-DEPLOYMENT IN A COLLISION RESULTING IN POSSIBLE PERSONAL INJURY.

2.Wait one minute for the backup power supply in the air bag diagnostic monitor to deplete its stored energy.
3.Remove the air bag simulator from the vehicle harness connector at the top of the steering column.
4.In stall the driver side air bag module.
5.Remove the air bag simulator from the vehicle harness connector at the passenger side air bag module.
6.Install the passenger side air bag module.
7.Reconnect the battery ground cable.

NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

8.Prove out the system.


This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20