Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



AllData Editors Note - Ford does not provide a cranking pressure specification, only an acceptable range.

1.Make sure the oil in the crankcase is of the correct viscosity and at the proper level and that the battery is properly charged. Operate the vehicle until the engine is at normal operating temperature. Turn the ignition switch to the OFF position, then remove all spark plugs.
2.Set the throttle plates in the wide-open position.
3.Install a compression gauge such as Compression Tester in No.1 cylinder.
4.Install an auxiliary starter switch in the starting circuit. With the ignition switch in the OFF position, use the auxiliary starter switch to crank the engine a minimum of five compression strokes and record the highest reading. Note the approximate number of compression strokes required to obtain the highest reading.
5.Repeat the test on each cylinder, cranking the engine approximately the same number of compression strokes.



This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20