Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



Two height sensors are mounted on the vehicle. The sensors send a voltage signal to the control module. The output ranges from approximately 4.75 volts at minimum height (when the vehicle is low or in full jounce), to 0.25 volts at maximum height (when the vehicle is high or in full rebound). The sensors have a useable range of 80 mm (3 in) compared to total suspension travel of 200-250 mm (8-10 in) at the wheel. Therefore, the sensors are mounted to the suspension at a point where full suspension travel at the wheel is relative to 80 mm (3 in) of travel at the height sensor. The front height sensor upper socket is attached to the bracket to the frame at the upper control arm mounting area and the lower height sensor socket is attached to the upper control arm bracket. The rear height sensor is attached between the No. 5 frame crossmember (upper socket) and the panhard rod (lower socket). Replace a sensor as a unit.

When the height sensor indicates that the vehicle is lower than trim under normal driving conditions, the air compressor will turn on and pump compressed air to the system. When the sensor indicates that the vehicle is raised above trim under normal driving conditions, this will cause the air to be vented from the system to lower the vehicle to its trim height level.



This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20