Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



Normal Operation
The air bag indicator is designed to light for six ({tag}6| two) seconds when the ignition switch is turned to the RUN position. This initial six seconds of air bag indicator illumination is considered normal operation and is called prove out of the air bag indicator. If there is an open in the air bag indicator circuit at Pin C208- 11, Circuit 608(BK/Y), a no air bag indicator fault will occur and this prove out will not be seen.

If the air bag diagnostic monitor detects an open in the air bag indicator circuit and another system fault exists, the air bag diagnostic monitor will turn on its internal tone generator (beeper). The beep pattern is five sets of five beeps. The pattern is repeated every 30 minutes while the ignition switch is in the RUN position. The five beeps do not indicate a Lamp Fault Code (LFC) 55 or any other LFC. The indicator circuitry must be repaired before the Diagnostic Trouble Code (DTC) can be read.

The air bag diagnostic monitor requires power at Pin C209-6, Circuit 298(P/O) to energize the air bag indicator circuit properly. Loss of ignition voltage at Pin C209-6, Circuit 298(P/O) due to an open circuit or short to ground will result in a continuous air bag indicator, due to the ignition voltage applied to Pin C208-19, Circuit 1044(W/Y); refer to Pinpoint Test R, Normal Operation.

If the air bag diagnostic monitor is disconnected or not firmly plugged in, a shorting bar in the black air bag diagnostic monitor harness connector C208 shorts Pin C208-10, Circuit 650(BK/LB) to Pin C208-11, Circuit 608(BK/Y), turning the air bag indicator lamp on continuously; refer to Pinpoint Test R, Normal Operation.

Possible Causes
An inoperative air bag indicator circuit can be caused by:
^a burned-out bulb or open wiring in the air bag indicator circuit.


This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20