Yandex MC
Alldata online

Alldata online. Is free

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru
Click for start

Diagnosis and repair



1.With the parking brake applied, perform the following:
a.Have an assistant rotate the steering wheel back and forth 360 degrees and watch for relative motion of the studs in the steering linkage ball sockets.
-Excessive vertical motion of the studs relative to the sockets may indicate excessive wear.
b.Watch for a loose steering gear attachment to the frame.

2.Raise the front tires off the ground, grasp the tire at the front and rear and watch for excessive play in the joints while trying to steer the wheels.
3.Steel, greaseable joints can be checked for excessive wear by measuring the torque it takes to turn the stud.
-Remove the tapered stud from its seat and thread the attaching nut back onto the stud.
-Turn the stud with an inch-pound torque wrench and note the torque required to turn the stud.

New Steel Joints: 2.0-5.3 Nm (17.8-47.3 inch lbs.)
Good Used Joints: 0.5-3 Nm (5-26.5 inch lbs.)
Joint with Excessive Play: Less Than 0.5 Nm (5 inch lbs.)

-Some joint turning torques will be as little as 0.5 Nm (5 inch lbs.) within the first 1000 miles and will remain there for the life of the joint.
-Only replace a ball joint that requires less than 0.5 Nm (5 inch lbs.).
-Tighten or replace loose, worn or damaged parts.

NOTE: Improper removal of the tapered stud will cause premature failure of the ball socket.




This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20