Yandex MC
Elsa online. ElsaWin. ElsaWeb. AudiPower transmissionServicing 7-speed dual clutch gearbox 0B5 (S tronic)Final drive, differential, differential lockExploded view - front final drive and oil sealsRenewing flange shaft oil seal (left-side)

elsawin online

DATACENTER ERROR!!! Внимание! Авария в датацентре!!


Subscribe to the telegram channel https://t.me/kolhosniki_en

Place for your advertisement

predsedatel@kolhosniki.ru

Attention! Please use superetka.com/elsa

Audi A7 Sportback

Please use
superetka.com/elsa

PLEASE USE https://SUPERETKA.COM/elsa
elsa on kolhosniki not support now!

Renewing flange shaft oil seal (left-side)
Special tools and workshop equipment required
    
t  Used oil collection and extraction unit -V.A.G 1782-
   W00-10211
t  Thrust piece -T40164-
t  Sealing grease → Electronic parts catalogue
   W00-10568
Procedure
l  Gearbox is secured to engine and gearbox support -VAS 6095- → Chapter.
–  Place used oil collection and extraction unit -V.A.G 1782- below gearbox.
–  Remove flange shaft (right-side) → Chapter.
–  Remove bolts -arrows-.
–  Carefully detach cover for front final drive (gear oil will drain off).
  Caution
Risk of damage to the differential.
t  Detach cover for front final drive slowly and carefully from gearbox housing. The differential may otherwise fall out of the gearbox.
t  A differential which has fallen to the ground can no longer be installed. Renew gearbox if differential has fallen to the ground.
t  Make sure that the inner bearing races and shims for the differential do not drop out of the gearbox housing and the front final drive cover.
t  Inner bearing races and shims cannot be re-allocated to their original positions by the workshop if they have dropped out.
   A39-10258
–  Carefully remove differential -arrow- and set it down on a soft surface.
–  Remove flange shaft (left-side) → Chapter.
   A37-10157
  Caution
Risk of damage to fitting surface in gearbox housing.
Apply screwdriver with care.
–  Press out oil seal from rear side using a screwdriver.
   A39-10194
–  Lightly oil outer circumference of new oil seal and slide onto thrust piece -T40164-.
l  Open side of oil seal faces towards thrust piece -T40164-.
–  Drive in oil seal for flange shaft (left-side) as far as stop using thrust piece -T40164-; keep seal straight when installing.
–  Pack space between sealing lip and dust lip half full with sealing grease; for sealing grease refer to → Electronic parts catalogue.
–  Fit differential.
   A39-10257
–  Install cover for front final drive with new O-ring and tighten bolts → Fig..
–  Install flange shaft (left-side) → Chapter.
–  Install flange shaft (right-side) → Chapter.
–  Fill up with gear oil (MTF) →7-speed dual clutch gearbox 0B5 (S tronic); Rep. gr.39.
   A39-10193

Didn't find what you were looking for? Try to find in:
- Mitchell onDemand online
- Alldata Online (Beta)

- ETKA ONLINE - login-pass from kolhosniki.ru

- NEW ELSA ONLINE - login-pass from kolhosniki.ru

This project exists mainly due to the display of advertising.

Due to the international situation, making a profit from advertising has become impossible.

If this continues, then the project will either close completely, or become closed and paid.

To support the project, you can Buy a paid subscription


Can be closed in 20